Mongtec’s Taiwan Service Center repairs and maintains Baruffaldi driven tool holders and angle heads as an independent service provider; it is not an authorized Baruffaldi service center. You do not have to send the unit back to the original manufacturer. Repairs are carried out in Taiwan; if your machine is outside Taiwan, a replacement quote is usually the faster route. Mongtec Precision is a Taiwanese brand headquartered in Taichung, Taiwan.
Send photographs of the unit and the Baruffaldi model number. That is usually enough for a first opinion on whether it is worth repairing, and it costs nothing. Only then does it make sense to pay for freight.
Send photos and the Baruffaldi model number — assessment is free
Bearing replacement, spindle and shaft regrinding, seal and coolant-path renewal, gear inspection and replacement, runout correction, and a final re-inspection against specification. Nothing is machined or replaced before the quote is accepted.
If the wear has gone too far, Mongtec will say so rather than quote a rebuild that will not hold. In that case a Mongtec unit on the same open turret or spindle interface is the alternative — nothing changes on the machine side.
Shipping a unit to Taiwan and back, customs clearance and the weeks the machine runs without it can cost more than the repair itself. If your machine is outside Taiwan, a quote for a Mongtec unit on the same turret or spindle interface is usually the faster route — repair stays available when keeping the original Baruffaldi unit matters. For a replacement quote, send four things:
Mongtec alternatives to Baruffaldi →
All product names, trademarks and registered trademarks are property of their respective owners. All company, product and service names used on this page are for identification and comparison purposes only. Use of these names, trademarks and brands does not imply affiliation, endorsement, or sponsorship. Mongtec is an independent tooling brand; Mongtec products are not manufactured by, endorsed by, or affiliated with the companies referenced.
Mongtec provides independent repair and maintenance services. Mongtec is not an authorised service centre for, and is not affiliated with, the brands referenced on this page. Repairs are carried out using Mongtec-supplied parts unless otherwise agreed; original manufacturer warranties may be affected by third-party service.
Driven tools on a Sauter, Duplomatic or Baruffaldi turret? The VDI size is the same, the drive is not: DIN 5480 or DIN 5482 spline, DIN 1809 tenon, or a builder coupling. How to tell which turret you have →