Axial (0°) driven tool holders drive the cutter parallel to the spindle axis, for face drilling, face milling and tapping into the end of the part while it is still in the chuck. Mongtec Precision, a Taiwanese tooling brand headquartered in Taichung, Taiwan, supplies them to mount on Muratec turrets.
Specially engineered and precision-matched for Muratec multitasking turning-milling centers, our 0° driven tools maximize machine performance to provide stable, high-efficiency, and high-precision machining support. From structural design to the transmission system, every critical detail is held to top-tier precision standards, ensuring consistent output and machining quality even under prolonged operation.
11 Muratec models. Where the turret interface is published it is shown; where it is blank the interface depends on the turret actually fitted and is confirmed at enquiry.
| Machine model | Turret interface (where published) | Turret |
|---|---|---|
| MD 60/120, MD 120 II | — | — |
| MD 100/200 | — | — |
| MT 12/200 | — | — |
| MT 20 | — | — |
| MT 25 | — | — |
| MT 1065EX (12-Station) | — | — |
| MT 100, 1051, 1065 (15-Station) | — | — |
| MT 300 | — | — |
| MW 40 | — | — |
| MW 400 (12-Station) | — | — |
| MSR 60 / MWR 120 | — | — |
All machine builders for 0° driven tools →
The machine model alone does not decide the holder. The same model can leave the factory with different turrets — station count, model suffix and key arrangement all change the mounting. Tell us the machine, the turret and the operation and we confirm the mounting before quoting.
Already using another brand? Send the drawing or the article number of the holder you run today and Mongtec will convert it to an equivalent Mongtec holder — same mounting, same reach, same output.
Mongtec publishes 0° driven tool holders for 11 Muratec machine models. On these machines the holder is used for face drilling, face milling and tapping into the end of the part. Article numbers are matched to the machine at RFQ — we confirm the turret interface from the builder’s drawing rather than assume it from the model name.
Muratec machine not on this list? Send the model and we confirm the interface →