Radial (90°) driven tool holders turn the drive through a right angle so the cutter works on the outside diameter — cross holes, cross tapping, flats, slots and keyways. Mongtec Precision, a Taiwanese tooling brand headquartered in Taichung, Taiwan, supplies them to mount on Focus CNC turrets, published for BMT55, BMT60.
Engineered specifically for Focus CNC multitasking turning-milling centers, our 90-degree driven tools provide stable and reliable side-machining capabilities, effectively addressing complex requirements for both face and lateral operations. Through high-precision transmission and a high-rigidity structural design, it enables multi-angle milling and drilling within confined spaces, significantly enhancing machining flexibility and overall production line efficiency on your Focus CNC equipment.
8 Focus CNC models. Where the turret interface is published it is shown; where it is blank the interface depends on the turret actually fitted and is confirmed at enquiry.
| Machine model | Turret interface (where published) | Turret |
|---|---|---|
| FBL-230MC | — | — |
| FBL-300MC | — | — |
| FBL-420Y | — | — |
| FBL-460MC | — | — |
| FBL-510, 520, 530, 540MC | — | — |
| FNL-160, 220LSY | — | — |
| FNL/FBL-250, 320Y/SY (12ST, BMT60) | BMT60 | 12-station |
| FNL/FBL-250, 320SY (16ST, BMT55) | BMT55 | 16-station |
All machine builders for 90° driven tools →
The machine model alone does not decide the holder. The same model can leave the factory with different turrets — station count, model suffix and key arrangement all change the mounting. Tell us the machine, the turret and the operation and we confirm the mounting before quoting.
Already using another brand? Send the drawing or the article number of the holder you run today and Mongtec will convert it to an equivalent Mongtec holder — same mounting, same reach, same output.
Mongtec publishes 90° radial driven tool holders for 8 Focus CNC machine models, on turret interfaces BMT55, BMT60. On these machines the holder is used for cross holes, cross tapping, flats and keyways on the diameter. Article numbers are matched to the machine at RFQ — we confirm the turret interface from the builder's drawing rather than assume it from the model name.
Focus CNC machine not on this list? Send the model and we confirm the interface →