Axial (0°) driven tool holders drive the cutter parallel to the spindle axis, for face drilling, face milling and tapping into the end of the part while it is still in the chuck. Mongtec Precision, a Taiwanese tooling brand headquartered in Taichung, Taiwan, supplies them to mount on Ganesh turrets, published for BMT40, BMT55, BMT65, VDI30.
Specially engineered and precision-matched for Ganesh multitasking turning-milling centers, our 0° driven tools maximize machine performance to provide stable, high-efficiency, and high-precision machining support. From structural design to the transmission system, every critical detail is held to top-tier precision standards, ensuring consistent output and machining quality even under prolonged operation.
9 Ganesh models. Where the turret interface is published it is shown; where it is blank the interface depends on the turret actually fitted and is confirmed at enquiry.
| Machine model | Turret interface (where published) | Turret |
|---|---|---|
| ASL-8/10/78 M(S)Y, ASL-52 TTMY (BMT40) | BMT40 | — |
| ASL-15 MY (BMT65) | BMT65 | — |
| ASL-78/105 TTMY (BMT65) | BMT65 | — |
| ASL-100 M (VDI30) | VDI30 | — |
| ASL-100 MY (BMT55) | BMT55 | — |
| Genturn 52/65 MSY | — | — |
| Genturn 52/78 TTMY, 78 MSY | — | — |
| SL-20 Y2 | — | — |
| Genturn WTS-Y2M | — | — |
All machine builders for 0° driven tools →
The machine model alone does not decide the holder. The same model can leave the factory with different turrets — station count, model suffix and key arrangement all change the mounting. Tell us the machine, the turret and the operation and we confirm the mounting before quoting.
Already using another brand? Send the drawing or the article number of the holder you run today and Mongtec will convert it to an equivalent Mongtec holder — same mounting, same reach, same output.
Mongtec publishes 0° driven tool holders for 9 Ganesh machine models, on turret interfaces BMT40, BMT55, BMT65, VDI30. On these machines the holder is used for face drilling, face milling and tapping into the end of the part. Article numbers are matched to the machine at RFQ — we confirm the turret interface from the builder's drawing rather than assume it from the model name.
Ganesh machine not on this list? Send the model and we confirm the interface →