CMZ Double 90° Driven Tools

Name: Mongtec CMZ Double 90° Driven Tools
Brand: Mongtec

Double 90° holders carry two right-angle outputs from one turret station, so two cross features are cut without indexing the turret between them. Mongtec Precision, a Taiwanese tooling brand headquartered in Taichung, Taiwan, builds them to mount on CMZ turrets.

Engineered specifically for CMZ multitasking turning-milling centers, these tools combine 90° lateral machining capability with a dual-output spindle design to significantly boost machining flexibility and production efficiency. Through a precision transmission structure, it handles side-machining requirements for both the main and sub-spindles within a single tool station, effectively reducing tool-change frequency and setup errors—making it the ideal choice for high-complexity component production.

Build features

Integrated Dual-Output Design — Supports dual-side tool configurations to shorten cycle times. It is particularly suited for automated mass production requiring frequent switching between main and sub-spindles.
High-Precision Runout Control ≤ 0.003mm — Maintains exceptional rotational precision even under dual-directional 90° transmission, ensuring dimensional consistency and superior surface finish quality.
Precision Ground Spiral Bevel Gear Pairs — Features high-quality paired-ground gears to ensure smooth and efficient power transmission between both spindles, offering low noise and minimal heat generation characteristics.
High-Rigidity Reinforced Housing — Specially designed for CMZ’s high-torque output, the reinforced housing absorbs lateral cutting vibrations, maintaining stability even during heavy-duty machining.
Imported P4 / P5 High-Speed Precision Bearings — Equipped with high-grade imported precision bearings throughout the series, ensuring superior thermal stability and long service life during high-speed, dual-tool cutting.

CMZ machines this holder is built for

13 CMZ models. Where the turret interface is published it is shown; where it is blank the interface depends on the turret actually fitted and is confirmed at enquiry.

Machine model	Turret interface (where published)	Turret
TA 15, 20 ,25, 30 (S)	—	—
TA 15, 20, 25, 30 M/MS/Y/YS (15 ST)	—	15-station
TA 15, 20, 25, 30 M/MS/Y/YS	—	—
TA Z400, 640, 1100 (15 ST)	—	15-station
TBI-520 A/B/C -MC	—	—
TC 15, 20, 25, 30, 35 (S)	—	—
TC 15, 20, 25, 30, 35 M/MS/Y/YS (12/16 ST)	—	16-station
TD 15-55 M/MS/Y/YS (15 ST)	—	15-station
TD 15-55 M/MS/Y/YS (12/16 ST)	—	16-station
TL 20, 25A, 25B	—	—
TL 20, 25A, 25B M/TM/MS	—	—
TTL / TX 52, 66	—	—
TTS 38, 46, 52, 66 M/Y	—	—

Other CMZ tooling

Double 90° Driven Tools for other machine builders

All machine builders for double 90° driven tools →

Getting the right holder

The machine model alone does not decide the holder. The same model can leave the factory with different turrets — station count, model suffix and key arrangement all change the mounting. Tell us the machine, the turret and the operation and we confirm the mounting before quoting.

Already using another brand? Send the drawing or the article number of the holder you run today and Mongtec will convert it to an equivalent Mongtec holder — same mounting, same reach, same output.

Send a drawing or an enquiry