Axial multi-spindle holders carry several parallel outputs on one station, so a bolt circle or a hole pattern is produced in a single stroke. Mongtec Precision, a Taiwanese tooling brand headquartered in Taichung, Taiwan, supplies them to mount on CMZ turrets.
Specially designed for CMZ multitasking turning-milling centers, featuring a dual-output spindle configuration aimed at maximizing machining efficiency and shortening cycle times. While maintaining CMZ’s signature high rigidity and high torque transmission, these multi-axis toolholders enable multiple operations in a single setup, providing an ideal solution for boosting productivity and Overall Equipment Effectiveness (OEE).
13 CMZ models. Where the turret interface is published it is shown; where it is blank the interface depends on the turret actually fitted and is confirmed at enquiry.
| Machine model | Turret interface (where published) | Turret |
|---|---|---|
| TA 15, 20 ,25, 30 (S) | — | — |
| TA 15, 20, 25, 30 M/MS/Y/YS (15 ST) | — | 15-station |
| TA 15, 20, 25, 30 M/MS/Y/YS | — | — |
| TA Z400, 640, 1100 (15 ST) | — | 15-station |
| TBI-520 A/B/C -MC | — | — |
| TC 15, 20, 25, 30, 35 (S) | — | — |
| TC 15, 20, 25, 30, 35 M/MS/Y/YS (12/16 ST) | — | 16-station |
| TD 15-55 M/MS/Y/YS (15 ST) | — | 15-station |
| TD 15-55 M/MS/Y/YS (12/16 ST) | — | 16-station |
| TL 20, 25A, 25B | — | — |
| TL 20, 25A, 25B M/TM/MS | — | — |
| TTL / TX 52, 66 | — | — |
| TTS 38, 46, 52, 66 M/Y | — | — |
All machine builders for 0° multi-axis driven toolholders →
The machine model alone does not decide the holder. The same model can leave the factory with different turrets — station count, model suffix and key arrangement all change the mounting. Tell us the machine, the turret and the operation and we confirm the mounting before quoting.
Already using another brand? Send the drawing or the article number of the holder you run today and Mongtec will convert it to an equivalent Mongtec holder — same mounting, same reach, same output.
Mongtec publishes adjustable-angle driven tool holders for 11 CMZ machine models. On these machines the holder is used for drilling and milling at angles between 0° and 90°, for features that sit neither on the face nor square to the diameter. Article numbers are matched to the machine at RFQ — we confirm the turret interface from the builder’s drawing rather than assume it from the model name.
CMZ machine not on this list? Send the model and we confirm the interface →